Battery chargers are required for initial charging of battery banks before putting into actual usages. The initial charging of batteries has a direct impact on the life of batteries. Therefore the application of these battery Chargers is critical. EXEL Digital Battery Chargers are Microcontroller based for precise charging as per the set values. These chargers are designed to operate in fail safe mode with all protections for unattended operation. The charger provide controlled voltage & controlled current charging irrespective of Input mains fluctuations. The final battery voltage & peak charging currents are adjusted initially as per requirement of battery.
| Capacity | 10 Batteries | 20 Batteries | 60 Batteries |
| Maximum Voltage | 160 V | 320 V | 320 V X 3 Strings |
| Maximum Current | 10 A | 10 A / 15 A | 15 A |
| Input Range | 150V -270V | 150V -270V | 150V -270V Three Phases |
| Oil Quantity | 35 Litre | 75 Litre/ 100 Litre | 300 Litre |
| Adjustment | VOLT Adj. / AMP. AMP. Adj. | ||
| Display | Set Voltage /Set current Battery Voltage / Battery Current |
||
| Over Current Protection | Above 10% of set value After 30 sec . Trip with FU (Fault Mode) on display | ||
| Over Voltage Protection | Above 10% of set value After 30sec . Trip with FU on display. | ||
| Short Circuit Protection | Instantaneous at 200% of set Value. | ||
| Soft Start | 30 seconds at every Input AC on. | ||